This tutorial will guide you through the way to use Voice Changer Software Diamond 8.0 (VCSD8) for changing your voice in Roger Wilco.
Click on the steps below to start
STEP 1: Turn on VAD mode in your VCSD8
On VCSD8 main panel, click Preferences to open VCS Settings window.
In Preferences tab, switch from Hook mode to Virtual Audio Driver mode:
- Check on Virtual driver Mode (1).
- Click OK (2) to apply the new setting and close VCS Settings window.
STEP 2: Get your voice ready with VCSD8
Open VCSD8, choose morphing effects and make adjustments for your voice until you achieve desired voice output.
STEP 3: Change audio settings in Roger Wilco
- Run Roger Wilco, and log in your account.
- Choose the Adjust tab » Click on Configuration button.
- Click Next until you reach the Configure Roger Wilco screen.
- In Recorder Device section, choose Microphone (Avnex Virtual Audio Device).
- Click Next then click Finish to finish the configuration.
From now on, VCS Virtual Audio Driver will be the main audio driver recognized by Roger Wilco.
STEP 4: Start voice call via Roger Wilco with the changed voice
You now can do voice call with Roger Wilco. The morphing settings for your voice will be applied automatically. Note: While VCS Virtual Audio Driver is being set as the audio driver for Roger Wilco, do NOT turn off VCSD8 when doing voice call via Roger Wilco. If you don’t want to use VCSD8, change the audio settings of Roger Wilco back to normal audio source.
(Source: audio4fun.com)
